What is the overall measurement of your cooking equipment in mm:*
(Width x Depth x Height)

Has the canopy a return wall to one or both ends?:*
(minimum 1200mm depth. On a centre island the wall must be full length of the canopy on that run, see image below) Wall type Centre island type

Overall canopy length in mm:*
(Remember to add 300mm to each end if the gas equipment is positioned at either end)

Type of cooking range:*
(Gas, Electric, Both) Gas Electric Both

If you have gas cooking equipment, do you require a Gas Interlocking control panel?: Yes No

Is all the cooking equipment electrical?: Yes No

Where will the duct exit the canopy: Rear Either End Roof Front

Where the hood is to be located:

External view of building where the ducting will exit the building on the outside include pictures of buildings close to this point Neighbouring property's:

How many metres of ducting will be required to reach the outside of the building?:

Total number of bends that require 90 or 45 degrees?:

Will the extract duct terminate on the wall or roof: Wall Roof

Do you require an Air Input System?:
(A mechanical system will most likely be required if you have gas cooking equipment.) Not required Integrated into the front face of the canopy with the duct exiting from the end of the canopy to the outside on the same floor level Integrated into the front face of the canopy duct vertically through roof Pod type through wall Pod type through roof

If you selected any of the roof options in the previous question, approx how many metres from the kitchen ceiling to the outside?:

Height of ceiling where canopy is to be installed?:*

Room size:
(Length, Depth & Floor to ceiling height)

Is the building listed or subject to any planning restrictions?: Yes No

If yes, please give details:

Do you require: Supply only Installation

By what date do you require completion:

Do you require stainless steel wall cladding?:
Please note returns to each end of the canopy are 1100mm deep to match canopy depth To rear wall only To rear wall and both ends To rear wall and left hand end To rear wall and right hand end

Any other notes or comments that may be helpful: